Reduce the wear and tear of the tripod and chassis, effectively increase the height by 25mm, prevent scratching the fuselage and gimbal, and can still take off and land under uneven ground conditions
Lightweight and stable frame, can stably carry the fuselage, almost does not affect the flight and endurance
Can be used as a mirror to the end of the bracket, handheld takeoff and landing
Triangular reinforcement design around the perimeter for more stable support
Front and rear use snap-on independent mounting, stable hook front and rear arms, stronger force, more stable
The tripod is designed to lie on the outside, 90 degrees downward shooting will not shoot the tripod
Easy to install, quick release and quick install, pay attention to differentiate the tripod serial number
The total weight of this night light bracket and flashlight without battery is about 60g, the drone can fly normally after installation
Adopt the screw adjustment method, the flashlight angle can be easily adjusted, so that the flight has more probing angle
The bracket is 3D printed and molded, made of plastic, with a sponge attached to the contact part of the fuselage, effectively protecting the drone from scratches, and easy to install
Using XPE-R3 lamp beads, brightness 120LM, long service life, high brightness, compact size, easy to install
One-piece design, which effectively improves the aircrafts adaptability to the ground environment during takeoff and landing, avoiding debris on the ground from dirtying the aircraft or damaging the lens
Lightweight design, does not affect the flight endurance
Precise fit, quick installation and removal, wear-resistant and durable
Replace your broken or unusable item with a new one.
Each item has been checked and in good condition before shipping.
Completely fit and work.
Professional installation is highly recommended. We will not be responsible for any damages to your device that you may cause during the changing of replacement parts.