Aluminum alloy locking buckle, to prevent the machine from falling, to ensure the use of safety
Precision weaving, tight and orderly not loose flat and strong, better load bearing
Rich colors are available for you to choose from to match your daily wear, to meet different scenes
Quick release design, one push to remove
Threaded installation, with cushion, safe and does not hurt the machine
Adaptable to a variety of camera models to ensure a stable and safe fit (note: sports cameras without 1/4 port need to be used with a rabbit cage or quick release)
Up to 5Gbps transmission rate, plug and play, hot-swap supported.
Easy to use, just follow the operating steps to insert the hub into the table hole. And the cable management hole can be removed so that the large plug of the data cable can pass through, more humane and practical design.
The desktop eyelet USB hub is innovatively installed into the grommet hole, making full use of the space on the desktop.
Only suitable for standard 60mm holes, please make sure your table hole diameter is 6cm before purchasing.
There are MOS and other components on the board, which are easily damaged by soldering iron induction electricity or static electricity. Please make sure that the soldering iron used is grounded (and the ground wire of the power strip is connected). It is best to wear anti-static gloves when operating.
Be careful not to install the battery upside down, otherwise the board may burn.
Please choose a power supply with sufficient power. Only in this way can the board work properly.
The board power supply should not be higher than 5V.
Please do not modify the board without technical confirmation.
It is normal for the module to heat up when working at high power, just pay attention to fanning.